How to Soundproof DIY Camper Van Conversion

As an Amazon Affiliate, EXPLORIST.life earns from qualifying purchases.

In its previous life, our Sprinter was a work van and despite being a Mercedes, it still was quite noisy driving down the road.  We decided to install FatMat Rattle Trap Sound Dampener to make the ride quieter for our campervan.

HOW MUCH SOUND PROOFING IS NEEDED?

In its previous life, our Sprinter was a work van.  And despite being a Mercedes, it still was quite noisey driving down the road.  We decided to install FatMat Rattle Trap Sound Dampener to make the ride quieter for our campervan.

Tools/Items You Will Need

Total Project Cost: $142.34

STEP BY STEP – HOW TO SOUND PROOF A CAMPER VAN

Clean the Surface:   Since this is a peel and stick application, you want to make sure you clean the surface of the van before you insall the Rattle Trap.  We used a simple vinegar solution to wipe down the metal.

Cut the FatMat RattleTrap into about 5-6 inch strips.  You don’t need 100% coverage on the metal to get the affect you want.  Really just the biggest surfaces are the most important, so you don’t need to be overly concerned about measurements. 

Peel and Stick. This is a pretty simple application, as it’s just a peel and stick!  We were most concerned with the larger areas of metal and the wheel wells.  We started with the wheel wells and worked our way through the big metal areas.

Heat it Up! We found that it was much easier to apply when it was heated up a bit.  We had a heater going in the van for warmth anyway, so we just used that.  You could also use a heat gun or a hair dryer to make it more pliable. 

Smash it! A little muscle with the roller smashes the edges down and makes sure your RattleTrap is fully applied to the metal.  Note that the Rattle Trap actually comes with a roller in the box.  Amazon didn’t mention this and it was a suggested add-on for our purchase.  While we didn’t purchase a roller, we can see how someone would buy one not knowing it comes with one.  So save the five bucks and buy yourself a beer instead! ?

That’s all there is to installing FatMat RattleTrap in a Mercedes Sprinter!  It didn’t take us very long at all and we got a good amount of coverage with the 50 square feet that we bought.  It made a world of difference in the sound of the metal, too.  That should kill some road noise!

SHOP ELECTRICAL SYSTEMS NOW

The EXPLORIST.life shop has everything you need for  your DIY camper electrical upgrade, retrofit, or complete system.

STAY UPDATED

Subscribe to the EXPLORIST.life weekly newsletter for updates, events, new tutorials & more oppourtunities.

SHOP ELECTRICAL SYSTEMS NOW

The EXPLORIST.life shop has everything you need for  your DIY camper electrical upgrade, retrofit, or complete system.

18 Responses

  1. Nate, thanks so much. Great post. Sounds like all you need is time and some patience, but not a lot of experience. Best, Trent

  2. Any fume or VOC down the road? I am very concerned with breathing crap gassing off the sound deadener..
    Any feedback?
    Claude

      1. Question, you mentioned in your insulating blog that you cleaned the walls with vinegar. You mentioned the same here. Are you cleaning the sound proofing and then putting spray adhesive on that for the insulation to stick to?
        Thanks!

        1. The vinegar was just to get grease off of the walls. Just simple cleanup so the adhesive would stick better.

Leave a Reply

Your email address will not be published. Required fields are marked *